In the PCB industry, the common types of copper foil are Rolled Annealed Copper (RA) and Electrodeposited Copper (ED).
Following these practical tips for high-frequency PCB design helps in optimizing interconnections within the board. Techniques such as using 45° transmission lines, precision etching, and non-leaded components will significantly enhance circuit performance. Familiarizing yourself with these methods makes designs like back-copper coplanar microstrip layouts both economical and efficient.
RF circuit board design is a critical and often complex area of PCB engineering. While there are many uncertainties in theory, practical design rules can be followed to optimize performance.
HDI boards represent the forefront of PCB technology, enabling smaller, more efficient electronic devices while meeting the demands of modern consumer electronics and telecommunications.
Printed Circuit Boards (PCBs) are the foundation of most electronic devices. The PCB production process can be categorized into subtractive methods and additive methods. Currently, the most commonly used industrial method is the copper foil etching process, a subtractive method.
HDI board is the abbreviation of High Density Inverter. It is a kind of (technology) for producing printed circuit boards. It is a circuit board with relatively high line distribution density using micro blind buried hole technology. HDI board is a compact product designed for small-capacity users. It adopts modular parallel design. One module has a capacity of 1000VA (height 1U), natural cooling, and can be directly placed in a 19″ rack. Up to 6 modules can be connected in parallel. This product adopts full digital signal process control (DSP) technology and multiple patented technologies. It has full range of load adaptability and strong short-term overload capacity, and can ignore the load power factor and peak factor.
In fact, there is no clear definition of HDI high-density manufacturing method, but generally there is a big difference between HDI and non-HDI. First of all, the aperture used in the circuit carrier made of HDI must be less than or equal to 6mil (1/1,000 inch), and the ring diameter of the hole ring must be ≦10mil, and the layout density of the line contacts must be greater than 130 points per square inch, and the line spacing of the signal line must be less than 3mil.
N4800-20 is a high-performance enhanced epoxy systems for multilayer PCBs requiring maximum thermal and stable electrical performance. It is designed to be lead-free assembly compatible and CAF resistant.
Gangrou combined with print circuit boards allows you to have the advantages of both the beauty. The rigid soft combination of PCB combines the flexibility of the flexible circuit and the durability of the rigid PCB. Flexible printing circuit boards are only flexible materials, which are usually based on polyimide or polyester. They can be single, double or multi -layer boards. The rigid soft combination of PCB also uses flexible and rigid materials. The flexible layer is sandwiched between the rigid layer. The rigid layer has conductors and plating holes to connect the flexible layer to other layers.
RF and microwave signals are very sensitive to noise -much more sensitive than high -speed digital signals. This means that you need to minimize the noise, bell, and reflection, and at the same time be careful to deal with the entire system.
Returning the signal with the least inductance -the ground floor below the signal will be easier to ensure this path.
Discipline matching is important. With the rise of RF and microwave frequency, the tolerance will become smaller. Generally, the PCB drive needs to be fixed, such as 50 ohms, which means that during the transmission and sending to the receiver, the drive outputs 50 ohms.
The transmission line that is curved due to wiring restrictions should use a curved radius that is at least three times larger than the central conductor width. This will minimize characteristic impedance.
It is necessary to minimize the return loss, whether it is reflected by the signal or the bell. There will always be a return path, but your design should guide it and prevent the return from multi -layer leakage through the PCB.
HDI PCBs have a higher density per unit circuit than traditional PCBs. They use a combination of buried and blind vias and microvias (0.006 inches in diameter or less). A high-density board is a PCB that has one or more of the following features: